Yesterday I had more than enough rice paste resist so decided to paste my new Meadow Rue pattern on two large pieces of 70% kozo (washi) Moriki paper from Wet Paint Art. I have wanted to make folded paper blinds for a room in our house, and this paper is the perfect size. The pasting worked well -- I didn't size or treat the paper with konnyaku (see previous post), but lightly misted it with water to relax/flatten it. This task was good practice pasting a repeat. The paper measures 25"x39," so I pasted 3 columns with my approx. 9x12 stencil, starting in the middle and working vertically down the length of the paper, and then the column closest to me. Finally, I rotated the paper 180 degrees to paste the far side. The indoor/outdoor carpeting worked well as a firm yet slightly giving surface underneath the work.
I plan to paint the paper with soy based pigments, and look forward to learning how well the paper holds up.
When I was nearly finished pasting, my stencil began to buckle a bit. This became especially noticeable after soaking it to remove the paste, as if the silk netting had shrunk. I am not sure why this happened since I followed the usual steps in attaching the netting including misting the stencil paper to swell it, aligning the weave appropriately, two coats of paint, air curing, etc. So, I carefully removed the netting, and then bought a new quart of porch floor latex. Perhaps the paint I have been using is too old. I will try again!
Here are a couple of illustrations of this problem: click to see the details.